Skip to main content

Driveshaft Selection Tool

Identify the right driveshaft length, coupling type, and material for your cooling tower's mechanical drive system.

* indicates required fields

Customer Information

DBSE: Distance Between Shaft Ends is defined as the length measured between the face of the gear box input shaft and the face of the motor shaft to within +/- 0.10 inches.

Reference the schematic below for more information.

Motor Data
Two Speed?
Variable Speed?
Gear Reducer Data
Fan Data
Schematic of a cooling tower drive: the driveshaft runs from the gear reducer's shaft end to the motor's shaft end, under the fan, and the distance between those shaft ends is the DBSE.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

More Tools and Calculators

Two rows of white fiberglass cooling towers with large fan stacks, seen from above at an industrial plant

Need a Budget Price for a New Tower?

Share your flow and conditions and get a budget bid for your project.

Bolt Sizing Chart

Quickly reference bolt dimensions, diameters, lengths, and specifications.

Find the right bolt size

Thread Sizing Chart

Quickly reference thread sizes and pitches.

Find the right thread size

Motor Selection Tool

Find the correct motor specification for your cooling tower fan based on horsepower, frame size, and speed requirements.

Find the right motor

NEMA Guide

Quickly reference NEMA motor frame sizes, dimensions, and mounting details.

Find the right frame size

Design & Price a Tower

Configure your cooling tower specifications and get an accurate parts and equipment quote tailored to your project requirements.

Design a tower

Water Usage Calculator

Estimate evaporation, blowdown, and makeup water consumption based on your tower's capacity and operating conditions.

Calculate water usage

Wet Bulb Temperature Chart

Look up wet bulb temperatures by region and season to optimize your cooling tower's thermal performance and sizing.

See the chart

Tonnage Duty Calculator

Determine the cooling duty in tons for your application by entering flow rate, temperature differential, and fluid type.

Calculate tonnage

Rental Tower Selection

Enter your flow and conditions to find the right rental tower module fast.

Find your rental tower

Budget Bid Request

Get a budget price for a new cooling tower based on your flow and conditions.

Start your bid

Frequently Asked Questions

What does a cooling tower driveshaft do?

The driveshaft transfers rotational power from the motor to the gearbox, allowing the cooling tower fan to operate at the required speed.

What causes cooling tower driveshaft failure?

Common causes include misalignment, excessive vibration, corrosion, worn couplings, improper installation, and prolonged mechanical stress. Regular inspection can help identify problems before they result in an unexpected shutdown.

What is the DBSE?

The distance between the ends. The correct DBSE ensures the driveshaft fits properly between the motor and gearbox while maintaining the required operating alignment.

Do bore size or keyway size matter?

Absolutely. This refers to the diameter of the opening in the driveshaft coupling or hub that fits over the motor and gearbox shafts. The bore must match the shaft diameter and keyway configuration to transmit torque properly.

Can I replace just the driveshaft instead of the entire mechanical system?

In most cases, yes. If the motor, gearbox, and other drive components remain in good condition, replacing the driveshaft or associated coupling components may be sufficient.

Get in touch

Contact us for sales, service, parts, emergency services, etc.